![]() ![]() Not sure why they didn't get created when I tried to start over, but I suppose it's all related. ini file(s) are (were) in the OLD RDP Wrapper folder. I currently have a RDP Wrapper folder, and an OLD RDP Wrapper folder. So I created a new RDP Wrapper folder and tried to install, and uninstall before posting here. I thought, before posting here, that I would just rename the RDP Wrapper folder, and start over. running RDPWInst -u from an admin cmd prompt give the same error, Failed to setup TermService. You are receiving this because you commented. I did download the installer.msi from github, which I don't think I'veĮver used before, but that didn't seem to actually install/do anything. Below is the exception as I have it setup, and also theįiles in program files/RDP Wrapper file, which is where I believe it's Suggested it, so I actually already did allow the exception, but I'm still That program, but came across an autoupdate batch file for RDP which I've never previously specifically allowed RDP in I just use the built-inĭefender in Windows 10. I don't have any stand aloneĪnti-virus programs installed normally, I only use that one for a one-offĬheck due to some weirdness I was experiencing. It was a stand alone virus program that deleted files (eset online), even Reply to this email directly, view it on GitHub You are receiving this because you are subscribed to this thread. I'm at a loss on how to simply remove RDP Wrapper altogether, so i If I try to run the uninstall.bat file that failsĪlso. I get an error message when i try to uninstall. I can see it listed in Programs and Features, but I've downloaded the files and tried installing, but it says Now, I cannot get it working again, nor can i ![]() Then, you can restore the registry if a problem occurs.I had this working for a long time, but when I ran an antivirus forĪnother issue, it killed RDP. For added protection, back up the registry before you modify it. Make sure that you follow these steps carefully. However, serious problems might occur if you modify the registry incorrectly. To do so: Important this section, method, or task contains steps that tell you how to modify the registry. Right click on run as you created earlier and selectĬlick command and from the right pane, right click on default and type in the following into Edit String box :Ĭlick Ok and close the Registry Editor windows Type Install as &Administrator in the value data box Right click on (Default) in the right pane of run as and selectĪn Edit String dialog box appears. If a User Account Control dialog box appears, click yes. Open run command and type regedit into the box and click Ok. I suggest you to follow the below steps and check if it helps. I would suggest you to check if Stream is compatible with Windows 10 in the Windows compatibility center. Thank you for posting in Microsoft Community. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |